Commands and Programming Examples

for the Programmable Digital Power Supply (DPS)

Introduction to programming

Connection and System requirements

Commands for PC programming

Commands for Master-Slave programming

Master-Slave connection diagrams

Setting Up a Master-Slave Application

Example of programming and operation of single DPS

Example of programming Master-Slave application

Diagram for programming example

Schematic for molding Medical Implantable RF Coil

Graph - sequence of operation steps example

The example program - storing program to DPS processor

Magtorx DPS devices are supported with unique programming features that can be used for a specific need. The programming possibility opens doors for many applications.  The DPS has very powerful programming capabilities, yet is very simple in operation.

The method of programming using Hyper Terminal as described in the examples is the most basic way of programming Magtorx Programmable DPS.  The other, more preferable method would be using a development program such as LabView®, Quick Basic®, Visual C++®, or MatLab®.  For example, using LabView you can develop a user interface program that will allow you to enter the command in a more friendly fashion where the user can create unit conversion VI’s or the specific command sub VI’s such as “Control Signal” in place of the cryptogram “LXXXX[CR]”.  Magtorx is working on developing an interface program, which will even more simplify programming the DPS.

Back to Top

---

Copyright © 2004  [MAGTORX]. All rights reserved. Rev. 1.1